FTP_SERIAL lets redirect debug info to an other port than Serial.FTP_DEBUG1 if defined, print additional info.FTP_DEBUG if defined, print to the Ide serial monitor information for debugging.FTP_FILESYST allows to define the files system used.You may have to modify some of the definitions in FtpServerConfig.h: Adafruit_SPIFlash and SdFat-Adafruit-Fork permit to use SPI flash memories instead of SD memories.This is useful if files name include accented letters but this increases the size of the sketch and the memory used.
FatFs lets you select the character encoding and the code page.Be sure to use version 2.0.2 or more recent. The new version of SdFat is the most recommendable as developed and maintained especially for the Arduino.In the Ide, open example FtpServerSpiFlash.Check files Adafruit_SPIFlash/src/flash_devices.h andĪdafruit_SPIFlash/src/Adafruit_SPIFlashBase.cpp to select your.In file FtpServerConfig.h set FTP_FILESYST to FTP_SPIFM.In the Ide, open example FtpServerFatFsĤ) Libraries Adafruit_SPIFlash and SdFat-Adafruit-Fork to access SPI memories.In file FtpServerConfig.h set FTP_FILESYST to FTP_FATFS.For low level access to memory card, need SdFat version 1.4.In the Ide, open example FtpServerSdFat2ģ) Library FatFs from ChaN adapted by me to run on Arduino.The correct value according to the format of your memory card Check the SdFat/src/SdFatConfig.h file and verify that SDFAT_FILE_TYPE has.This library allows to use the exFat filesystem, in addition to Fat16/32.Make sure that a version 2.0.2 of the SdFat library is installed.In file FtpServerConfig.h set FTP_FILESYST to FTP_SDFAT2.Select single data connection mode when availableĢ) New library SdFat version 2.0.2 from William Greiman Protocol set to normal FTP server (no encryption),
Open a session in a Ftp client (user "arduino", password "test",.Upload it and watch the initialisation steps in the serial monitor.Study the example and modify it according to your hardware.In the Ide, open example FtpServerSdFat1.Make sure that a version 1.4.x of the SdFat library is installed.In file FtpServerConfig.h set FTP_FILESYST to FTP_SDFAT1.Modify #define FTP_FILESYST according to the files system library you are usingġ) Library SdFat version 1.4 from William Greiman Tested with Ide 1.8.13 on Arduino Due and MKR with ethernet module W5100, W5200 or W5500įatLib and Streaming libraries are not more usedĮdit file FtpServer/src/FtpServerConfig.h and
To locate that setting, go to Configuration > Authentication > IWA > IWA Servers > Allow Basic credentials.= How to use FtpServer on Arduino = If you have used these steps and Filezilla continues to fail, make sure Allow Basic credentials is selected on your IWA Servers tab in your IWA authentication settings. Also, if the proxy is not configured for authentication and you are having trouble using the syntax, try removing the proxy username and password variables (" %s" and "ACCT %w") and be sure not to include a trailing space after the variables. NOTE: If Filezilla intermittently works (it works once, and then fails for a while, and then works again), please see 000014404 for a way to work around the issue. Filezilla will connect to the ProxySG appliance and pass the remote host, remote host credentials, and appliance credentials. The ProxySG will then establish a connection to the FTP server using the credentials provided by the user.